NetBurner Community Forum

Did this ever get itself worked into NBEclipse? I couldn't find an example file, only a header, but there wasn't much in there to go with.

Ok, I've got a few questions: Do you know the destination IP address when you create the IRQ7 packet? If you know the destination IP, do you also know the hardware MAC address? The problem with trying to just send a packet from your level 7 IRQ is that when it gets down to the bottom of the world, ...

How about setting up the packet ahead of time, so the irq7 only posts the semaphore, and your highest priority task is only a pend and send udp packet? An interrupt will call the scheduler, so after the irq7 returns, the highest task ready to run will run, so you do not have to wait for the task th...

I'm trying to do the impossible, the forbidden. I'm trying to send a tiny UDP packet from an IRQ7 interrupt function. I've created a circuit that raises the IRQ7 pin high when the circuit board voltage drops below a certain level (Undervoltage Lockout or UVLO). What I've been able to do in the inter...

Thanks Paul,

I must have had some form of typo in there. I deleted and retyped it and it worked. Thanks!

I realize it's 2 years later, but has any of this been incorporated into the NNDK2.7.3? I need to use I2C 0 and I2C1 for a project and am hoping not to have to go through all these steps to use it... or change my board design.

Not sure if this topic has been discussed before or not. I'm trying to output a double precision value to MTTTY. I'm getting weird numbers... volatile double numberz[16] numberz[0] = 5.01021; numberz[1] = 3.33205 /// etc up to index 15 for (int i = 0; i < 16; i++) printf("Output: %2.6f\r\n"...

Hi, thanks for responding, I did figure out the problem. There was a misconfigured interrupt, that's all. Thanks anyway!

Hi all, Just wondering if someone could tell me if I'm missing something - I'm running the debugger and even though I have set breakpoints, the system is just running past them regardless. Does the debugger run at a different IP address than what is set in the unit? MY debug configuration is set cor...

That wasn't my only issue - it would freeze up at random points too and I'd get the TaskScan message in MTTTY just before it would reboot itself. But the freeze point became a bit sporatic - so it never froze in the same place all the time...