NetBurner Community Forum

I'm seting the TSTRIP5 port for CAN use.
I have some doubts when it comes to connect these optional jumpers:

JP3 HSR (High slew rate)
JP21 GND
JP21 PIN (Power IN)


1) when JP21 is present at 2-3, is the TSTRIP5 pin 1 GND identical to pin 3 GND?
2) the HSR jumper sure is related to the pin RS of the 82C251 but how?

I'd need the schematic of the optional "in-bus" power & CAN driver section of the CB34EX
thanks

Hey guys please, I'm stuck on this, I need the schematic….

Hi,

This is a customer forum, not a sponsored NetBurner forurm. I don't think we, as users, can redistribute system source code or hardware design information.

I’m Sorry…. I thought the Netburner people were involved here…