Page 1 of 1
YouTube example of using Netburner to set thermostat value
Posted: Sun Oct 18, 2009 4:13 am
by Kiwinet
Here is a brief trivial example of me setting the setpoint value of a serial(RS232) enabled temperature controller
through a SB70LC Netburner webpage via Internet or LAN.
See
http://www.youtube.com/watch?v=ga3LWVrRCv0
Early days yet, I hope to have the project fully completed in Adobe Flash web interface
in just a few months time, during my spare weekend time.
Cheers
Paul
http://microwebserver.net
Re: YouTube example of using Netburner to set thermostat value
Posted: Sun Oct 18, 2009 8:50 am
by Vernon
Your link does not come up.
Re: YouTube example of using Netburner to set thermostat value
Posted: Sun Oct 18, 2009 12:56 pm
by Kiwinet
Hi Vernon,
You may wish to give the YouTube link another try, it is not dead
, the video has had an additional number of viewing hits since you last logged onto this forum.
Best regards
Paul
Re: YouTube example of using Netburner to set thermostat value
Posted: Mon Oct 19, 2009 11:22 am
by Vernon
Kiwinet wrote:Hi Vernon,
You may wish to give the YouTube link another try, it is not dead
, the video has had an additional number of viewing hits since you last logged onto this forum.
Best regards
Paul
The link below your signature is dead.
Re: YouTube example of using Netburner to set thermostat value
Posted: Mon Oct 19, 2009 11:05 pm
by Kiwinet
Hi Vernon,
I simply solved the Netburner website link problem by a power OFF/ON hardware reset on both my ADSL2 modem and VOIP 4 port hub router.
It appears it was a Dynamic IP addressing issue between my 4 port ethernet hub router & modem.
Before the WAN IP address was 10.1.1.4, after power on/off reboot it changed to 10.1.1.3. seemed to have fixed it.
I always have my Netburner IP address set to DMZ by the router, so I was surprised when you mentioned didn't work?
So do you think assigning static addresses between the router and modem is a better or worse long term solution or
it maybe just a one off glitch with my interfacing hardware. DHCP seems to be relatively fuss free & reliable so far.
Happy Netburning then
Paul
Re: YouTube example of using Netburner to set thermostat value
Posted: Tue Oct 20, 2009 6:40 pm
by Vernon
I assign static addresses and also put the Netburner in a DMZ. It is very intermittant however and I am waiting for a new router to see if the router is the problem.
http://www.cttestset.com/camtest.htm
The netburner hosted control console is on the right side of the screen.
Your site is working now and looks good.
Re: YouTube example of using Netburner to set thermostat value
Posted: Tue Oct 20, 2009 8:19 pm
by rnixon
Tried your link, and it is working great. Did about 10 reloads, worked every time.