NetBurner Community Forum

My problem is the factory demo worked great. When I attempted to upload some simple changes everything halted. Can't seem to connect from NBEclipse. I can get in with mttty and all I get i is 'application running'. When I abort I can run setup, boot but it reports reboot as an unknown command. Did I send garbage to a section of flash or somewhere I shouldn't have?

=====

Update - I figured out why I get 'application running' - it was in the last successful upload. My problem is I am not connecting serially to upload the new program. Any suggestions?

I would try a serial load of the factory app. Once that is on the board, try loading your code again via NBEclipse.

See
http://wiki.embeddedethernet.com/Suppor ... _via_MTTTY

This details how to load a new app via MTTTY through serial. In your case you won't be loading tictactoe. Instead, load the original mod5213factoryapp. This is loacted in the c:\nburn\mod5213\original directory.