When trying to load a new xxx_APP.s19 to my MOD5213 I keep getting the messages:
Serial Load: Failed to open file
Serial Load: Failed to Connect to serial port
I did notice only and ending " on the file name and that might have something to do with the first problem. I am not using SpeedSerial or The USB port on the Dev board, I could never get them to work on any current version.
I went back to ver 2.6.0 and everything worked including Debug.
Regards
TimC
NNDK 2.6.1 with MOD5213 no download no debug
Re: NNDK 2.6.1 with MOD5213 no download no debug
Hello,
Thanks, I confirmed this and added a fix to the next release candidate. I expect a new RC in about a week.
Thanks, I confirmed this and added a fix to the next release candidate. I expect a new RC in about a week.
Forrest Stanley
Project Engineer
NetBurner, Inc
NetBurner Learn Articles: http://www.netburner.com/learn
Project Engineer
NetBurner, Inc
NetBurner Learn Articles: http://www.netburner.com/learn
Re: NNDK 2.6.1 with MOD5213 no download no debug
It's been difficult to profile the MOD5213 problem now on 2.6.2.
I have had some success with 2 machines running XP but on a 3rd running Win7 I get a total lockup on the load step, followed by a lockout of my Workspace. Running Mttty before loading is a must.
IP based serial ports work the best
Old fashion Hardware serial ports work OK
FTDI ports seem to cause the most lockups
Earlier versions < 2.6.1 were great.
I have had some success with 2 machines running XP but on a 3rd running Win7 I get a total lockup on the load step, followed by a lockout of my Workspace. Running Mttty before loading is a must.
IP based serial ports work the best
Old fashion Hardware serial ports work OK
FTDI ports seem to cause the most lockups
Earlier versions < 2.6.1 were great.