Page 1 of 1
LabVIEW and Netburners
Posted: Fri Feb 12, 2021 8:19 am
by tpannone
I know that there are third-party add-ons to allow LabVIEW to run on platforms like Raspberry Pi and Arduino.
Has anyone attempted to create an add-on to allow LabVIEW to run on Netburner core modules?
Re: LabVIEW and Netburners
Posted: Wed Mar 17, 2021 5:21 am
by tpannone
I will take the lack of replies as a no.
Re: LabVIEW and Netburners
Posted: Thu Mar 18, 2021 10:07 am
by pbreed
You can use the TCP capabilities of LabView and write a driver?
Re: LabVIEW and Netburners
Posted: Fri Mar 26, 2021 11:09 am
by tpannone
That would be way above my paygrade.
Re: LabVIEW and Netburners
Posted: Fri Mar 26, 2021 1:56 pm
by TomNB
I have not tried this myself, but the labview people think it is doable a few steps:
https://www.ni.com/getting-started/set- ... et-connect