NetBurner Community Forum

I need to set up one of the etpu uart ports for 8 data bits, no parity, and 1 stop bit. The function:
int eTPUFDUartOpen(int RXchannel,
int TXchannel,
int baud_rate = 115200,
int bits_per_data_word = 8,
int parity = FS_ETPU_UART_NO_PARITY,
int priority = FS_ETPU_PRIORITY_MIDDLE);

does not seem to have the typical uart stop bit configuration options. Is this possible, or are the etpu channels fixed at two stop bits as the only option?

Thanks