NetBurner Community Forum

Hi All,
Today from support-netburner-com/SelfService/Tools.html web page, I down loaded V3 of the NNDK onto a fresh machine.
I created a new project using File->New Project->NetBurner Project wizard (just a simple test). Main.cpp was generated by the wizard.
When I try to build this i get

3:58:26 **** Build of configuration Release for project myTCP ****
make -j4 all
Cannot run program "make": Launching failed

Error: Program "make" not found in PATH

I noticed that in the NetBurner Options tab there are no Target platforms in the drop down menu but I can find my device IP address.
I also noticed that compared to the NNDK 2.8.7, there are several sub directories missing in the install of the \nburn directory. E.g. gcc-m68k, include, various device directories etc I suspect this may be the problem.

So my question is have I missed something or am I being stupid? So I need to install something else first?

I am developing code to run on the SB70LC.

many thanks
Pete

I'm not sure if the new release will support the SB70LC

In the release notes for 3.0.0 it says:

HARDWARE

• Support for ARM processors, starting with the 300MHz M7.
• Applications easily scale from single chip solutions to large memory platforms.
• Support for NXP/Freescale 5441x based products:
  • MOD54415
  • MOD54417
  • SB800EX
  • NANO54415
  • For other NetBurner platforms we will fully maintain the 2.8.x branch.

"For other NetBurner platforms we will fully maintain the 2.8.x branch."

Yeah, I read that and it raised suspicions. It doesn't explicitly say it wont, but I'm guessing its the case. If this is so, then perhaps a more "in your face" statement on the website before getting to the download page would have prevented me wasting several hours time.
Onwards and upwards