Network connector specification

Discussion to talk about hardware related topics only.
Post Reply
premiaware
Posts: 11
Joined: Tue Jun 17, 2008 5:25 am

Network connector specification

Post by premiaware »

Hi,

I have try to use the MOD5270 v200 without embedded ethernet connector. In my pcb design I have many problems with electromagnetic interference (EMI). Where i can find the ethernet design guide to connect my ethernet jack in correct position?

Thank'you
User avatar
lgitlitz
Posts: 331
Joined: Wed Apr 23, 2008 11:43 am
Location: San Diego, CA
Contact:

Re: Network connector specification

Post by lgitlitz »

There is a brand new Ethernet layout guide available on the technical documents page under "various platforms". Here is the direct link:
http://www.netburner.com/downloads/nndk ... ign200.pdf
DBrunermer
Posts: 67
Joined: Thu Apr 21, 2011 7:06 am
Location: Pittsburgh, PA

Re: Network connector specification

Post by DBrunermer »

I think this link might be broken, or the document isn't properly encoded. I keep getting errors. - Dan B.
User avatar
Jon
Posts: 79
Joined: Mon Feb 05, 2018 10:54 am

Re: Network connector specification

Post by Jon »

I'm not sure if this is the same guide that was mentioned previously, but there is an Ethernet Connector guide here as well:

https://www.netburner.com/support/doc-s ... -35-3/file

(though it looks like from another post that you might have already found this...)
User avatar
TomNB
Posts: 538
Joined: Tue May 10, 2016 8:22 am

Re: Network connector specification

Post by TomNB »

Hello,

The latest app note is attached.
Attachments
AddEthernetRJ45Connector.pdf
(511.39 KiB) Downloaded 241 times
Post Reply