NetBurner Community Forum

I verified rts/cts connections were correct. I had enabled both on the configuration page. The microcontroller has rts/cts. The SBL2e has two UART but only in one rts/cts lines, so I cannot control both. However, I think that is not the problem. I’m using TCP and all default configuration. One modul...

TomNB: We checked the rts/cts lines with an oscilloscope and they never change, so, that is not the problem. Also we put both channels at 57600, with same results. pbreed: We connected the module directly a PC (and we did the test with different PCs), so there are not any router/switch/etc. The ping...

It is important to enphasize that the problem occurs when both channels are use at the same time simultaneously.

What baud rate are you running at? We tried both in 115200, both in 57600, one 115200 and the other in 57600. We always lost data. Are you running two instances of realterm? I am not familiar with it. Does it somehow try to handle two data streams in a single instance? Yes, we open two realterm inst...

Hi! We are using SBL2e Dual Serial-to-Ethernet. The module has the configuration default except the ip and port. We use static ip and we changed the port 23-24 to 81-82. We put hexa data into both serial port (Port 0 and Port 1) and we start reading the TCP stream with a terminal (RealTerm). When we...