NetBurner Community Forum

Tom,
Thank you. I appreciate it.

mlara,

Great. Thank you. That should help a lot.
I did notice the '#ifdef' for the various platforms, but I missed the '#else' - where Pins is defined.

On the PK70 board. I want/need to install an interrupt service routine for PIT1. Netburner software for the MOD5441x includes this macro to assist with setting the interrupt controller: SETUP_PIT1_ISR(&pit1_isr_asm, 5); Does that macro, or an equivalent, exist for the PK70 ?? If so, what include...

For the MOD5441x, Netburner provides a function to control GPIO lines. For example J1[6] = 0, sets that line as an output and drives it low. Is there an equivalent function for the PK70 ?? If so, what is the syntax and what is the include file ?? I tried this line to set that pin to GPIO: J1[6].func...

I just found the problem - and it is me. I had commented out "GATHER_RANDOM" in "predef.h"; and forgot that I had done that. I have not un-commented that line and rebuilt all the system files, yet. But I'm sure that will fix the problem. Sorry to have wasted your time. (You are w...

I removed "Dual Stack Mode" and went to IPv4 only by modifying the "predef.h" file, per the instructions in "IPv6DualStackMode.pdf". I rebuilt the system files, the libraries, and all system files for each platform (all from the command prompt). I can now build all the ...

Experiment #2. I used the wizard to create a project, I checked "AutoUpdate", "Webserver" and "Stack Check". Only one source file in the project (main.cpp). Contents: ---------- #include <predef.h> #include <stdio.h> #include <ctype.h> #include <startnet.h> #include <au...

I deleted the PK70 project. I created a new (empty) PK70 project. Imported the factory demo. Tried to build the project. Exact same results. Doubtful this will help, but here is the Build Console listing (complete). The errors are near the bottom of the listing, they stopped the build. Your help is ...

I renamed my existing installation to "Netburner_277". Then I did a clean install of 2.8.7 I also created a MOD5441x project (and copied my source files). That project compiled properly under 2.7.7. When I tried to compile it under 2.8.7 it resulted in the exact same two errors. Later toni...

This question is probably easy for someone. Hopefully they can help me save time. I just installed version 2.8.7 (MS-WIndows XP) with two hardware platform licenses (MOD5441x and PK70). I rebuilt the system files (it defaulted to the other hardware platform: MOD5441x). Using a command window I went ...