Search found 3 matches

by timmmmeh
Tue Dec 18, 2012 2:32 pm
Forum: NetBurner Hardware
Topic: Fried PCB Board on power up
Replies: 6
Views: 4483

Re: Fried PCB Board on power up

Hi pbreed, Thank you for the additional information. We do use the 72ex as well without any problems. All devices get power from the same source. Not sure if I mentioned this in my initial post, but the unit powers up and stays on perfectly fine. It's not until we plug in the CAN data plug which the...
by timmmmeh
Tue Dec 18, 2012 1:27 pm
Forum: NetBurner Hardware
Topic: Fried PCB Board on power up
Replies: 6
Views: 4483

Re: Fried PCB Board on power up

Thank you for your help, but I have not had the time to revisit this yet. When you say tie a ground from the data ground to the power supply ground, do you mean the -24VDC of the power supply? So a wire from where I am picking up -24VDC to the data ground on the plug?
by timmmmeh
Wed Dec 12, 2012 12:07 pm
Forum: NetBurner Hardware
Topic: Fried PCB Board on power up
Replies: 6
Views: 4483

Fried PCB Board on power up

Hey Guys, I've been using the CB34EX for quite some time now on over 50 vessels (2 per boat). I tried replacing a couple of these due to failures, but every time I plug in a new one, they burn up right away while powering them up. Interestingly, however, is that the other one (older version) is bein...