I FINALLY GOT IT TO WORK!!! WAHOOO!
I hate when people never follow up with the solution to their problem so here it is:
I had 2 problems:
1. I am very new to micro controllers and electronics so my first problem was that I didn't ground both modules together (common ground). Rookie mistake ...
Search found 3 matches
- Sat Jan 08, 2011 7:50 am
- Forum: PINK
- Topic: PINK Communication Problems (with AtomPro)
- Replies: 3
- Views: 10703
- Sat Dec 18, 2010 7:59 am
- Forum: PINK
- Topic: PINK Communication Problems (with AtomPro)
- Replies: 3
- Views: 10703
Re: PINK Communication Problems (with AtomPro)
Thanks for the reply!
I will play with it this weekend and hopefully figure it out.
On another note, why does the PINK troubleshooting screen say:
Received from stamp:[1]
Received from stamp:[5]
Received from stamp:[0]
Received from stamp:[<CLS>]
To me this says that the "stamp" is sending back ...
I will play with it this weekend and hopefully figure it out.
On another note, why does the PINK troubleshooting screen say:
Received from stamp:[1]
Received from stamp:[5]
Received from stamp:[0]
Received from stamp:[<CLS>]
To me this says that the "stamp" is sending back ...
- Fri Dec 17, 2010 9:27 am
- Forum: PINK
- Topic: PINK Communication Problems (with AtomPro)
- Replies: 3
- Views: 10703
PINK Communication Problems (with AtomPro)
All,
I am currently trying to interface the PINK Parallax NetBurner (#30013) module with my AtomPro. I was able to set up and configure the module with little to no effort (via Ethernet). Then I connected it to my AtomPro and had no problems sending it commands: SEROUT TX, Baud, ["!NB0W01:",dec3 150 ...
I am currently trying to interface the PINK Parallax NetBurner (#30013) module with my AtomPro. I was able to set up and configure the module with little to no effort (via Ethernet). Then I connected it to my AtomPro and had no problems sending it commands: SEROUT TX, Baud, ["!NB0W01:",dec3 150 ...